Magna / Verada owners from TE (KE) 1996 - TW (KW) 2005 Discussion here.
just wondering if it is my clutch?? went the cars is cool and i am releasing the clutch only in 1st gear the car shudders like if the clutch is slipping but it is find when the car is warm usally happen about 1-2 times a week when i am reversing the car out of the drive way but it would be...
Ok guys I have asked a couple questions about my cruise control but didn't really tackle the problem. I was driving along with the cruise control set on 100 then all of a sudden on a flat bit of road the car accelerated to 120 then dropped back to like 90 then up to 120 again then back to 90 it did...
Hey dudes, this is most likely a stupid question but i'm just after some advice because this weekend my TJ 3.5 Auto gets on the rollers to see if she can pull some impressive figures (well i hope so :? )! Anyway, I've been searching the net and reading up on how they dyno automatics. Now I know...
Just thought that this would look good and was wondering if anyboady has ever done this and how much it would cost 8)
Hey guys... been doing a lot of painting lately.. Here's my engine bay all done
Hey guys Im wanting to chop my shifter.. Its sitting way too high at the moment.. Was wondering if anyone has a guide on removing the shifter so i can chop it.. Just not 100% confident with the cables and all thats in there.. Thanks
I had a convex left side mirror on my soarer which i loved, let me see what was going on alot easier, chances are the jap spec magna's will have this just wanna know if its possible to get a convex mirror for the magna i know by law you cant have the right hand side, but i know u can have...
Hey Guys Ive got a 93 Verada with the old 12valve V6, which is starting to show signs of piston ring wear, and a few oil leaks. I'm pondering getting it reconditioned rather than just fixing the rings or valves as its nearing the 200,000kms mark. Just wondering if anyone else has a few anecdotes...
Ok went over to my mates place 1pm too swap the lowered suspension and rims from my old TE 4cyl man. to the new TH Sports 6cyl SA. Sounds easy :) Well it was pretty easy not that much room so I had to move the TE in and out to turn it around a few times to get to all of the wheels . Any way...
Right i just threw in the K&N pod filter - yeah yeah noise power etc etc ANYWAY!, there is knowhere for decent cold air induction so stupid here had an idea \:D/ :idea: What if i moved the battery say into the boot, then i would have heaps of space to do whateva! I know i would have to keep...
Here's what I was up to few nights ago at 3am. Paints the wrc blue. Instead of using normal paint I use paint for remote control car polycarbonate bodies. Seems to be much tougher, dries quicker, finer spray and is heat resistant (to about 60 degrees). Its usually used on polycarbonate bodies...
ive had this problem for a while but only on start up for a few seconds then it developed into slipping under torque now when i start up the whole car shudders and when i put it into drive i cant go anywhere its as if its trying to go forwards and backwards at the same time :cry: please can...
Well, I took my VRX in to get a warranty job on it. The left passenger air vent was broken .. I broke it when cleaning the car. While in their i had them look at the windscreen motor. Was making an intermittent noise. They replaced the Vent and the wiper motor. Did a check over the car and found...
i put up this post before but lost it. so for those who responded to it before, please bear with me. my 99TH magna only has 95,000 kms on the clock and the auto transmission likes to shift intself into neutral when it's in D. i have to tap on the accelerator to get the gearbox to engage again...
Guys :-$ , i'm getting my cat back done on the V6 TS tomorrow morning cause my extractors arrive mid week. Stock piping is 2 1/4. Should i get 2½ or 2 3/4?? mind you i'm planning on rebuilding the heads in the next few months including port/polish, higher compression maybe stage 1 cams. Any...
hmm been told something today wen i went to king springs to buy 2 sets of super lows, he said they didnt actually stock and super lows that would go on the rear because he said they fall out ???? i got 18"'s put on it and there isnt really much of a gap ne ways and it looks hot, but still in the...
Hi guys just bought me self a 1992 TR magna today with 162000km's on da clock. However it seems to be Idling to high, it hovers around 1800rpm then intermitantly drops to about 1600rpm every few seconds.. She runs just fine, by the way it's the 2.6 efi in manual. Just wondering if anyone else has...
hey all, got a quick question. my dad just had his rear skirt on his tj damaged and needs a new one. he's looking at getting the vrx rear. but in all the pics of the vrx it has 1 exhaust pipe thingy and his has the standard 2 little things. would this still fit okay or would it be in the way or...
When i get my head work done shortly, i want to put in new cams, springs etc. Stage 1 doesn't increase much power, just offers smoothness but i wanna go fast! Stage 2 cams "may" need a new computer (haltech) which i really don't wanna fork out for but the cam offers more power (more power is a good...
im starting to think maybe we should rename the tech forum to "v64 needs help with" I just had the nice people at racv replace my battry for free as it was under warranty but now the car is idling out! :( i can rev it, and keep the car going, but when im watching the rev's its sitting at...
There are currently 74 users browsing this forum. (1 members & 73 guests)
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
